THE TWO NUMBERS
Bend and straightening
Bend (flexion) is how far the shin turns back from the line of the thigh, in degrees. Straightening (extension) is how close the knee comes to a straight line; it is usually written as degrees short of straight, so 0 means fully straight and 5 means five degrees short.
Your surgeon or physical therapist measures both with a goniometer at your visits, and their reading is the one in your chart. Measuring at home between visits tells you whether your own number is moving.
METHOD 1
The photo method, step by step
- Set up the same way every time. Bend: sit on a firm chair, or lie on your back, and slide the heel back as far as it comfortably goes. Straightening: lie on your back with the heel on a rolled towel and nothing under the knee, and let the knee sink toward the bed. Shorts on, so the bony points show.
- Have a helper take the photo from the side. The phone is level, at knee height, square to the leg (not from above or at an angle), about two to three metres away, with the hip, knee and ankle all in the frame. A photo taken at a slant changes the angle, so this matters more than anything else.
- Mark three points on the photo. The bony bump on the outside of the hip, the outside of the knee at the middle of the joint, and the bony bump on the outside of the ankle. Draw a line from the hip mark to the knee mark, and from the knee mark to the ankle mark.
- Measure the angle at the knee. Use a protractor on the printed photo, or any angle tool on the screen. The bend is 180 minus the angle you see at the knee: an angle of 70 degrees at the knee is a 110-degree bend.
- Read straightening the same way. With the leg out straight, 180 minus the angle at the knee is how many degrees short of straight the knee is: an angle of 175 degrees is 5 degrees short of straight. Zero means fully straight.
- Write down the number, the side and the date. Compare it only with your own earlier readings taken the same way. A change of a few degrees is within what the method itself varies.
A slanted photo, a different chair or a different time of day each changes the number. Keep the setup the same, and read a small change as no change.
METHOD 2
No helper: the phone on your leg
At jointcoach.com/bend, lay your phone flat on your thigh, then flat on your shin. The phone's tilt sensor reads each slope and the page adds them: that is the bend. The same two readings with the leg laid out give degrees short of straight. It needs no camera and no account, and the readings stay on your phone, compared only with your own earlier ones.
Your next step here: measure your knee bend now
BEFORE YOU PUSH IT
Ask first, and know when to call
Ask your surgeon or physical therapist how far, and how often, to work the bend in your own recovery. Measure where the knee comfortably goes, not where it hurts.
Call your surgeon’s office for a fever, a red or draining wound, new pain or swelling in the calf, or a sudden loss of bend you already had. For a quick check of where you are in recovery, see today’s recovery check.
Done here when your bend and straightening numbers are written down with the side and the date, or kept on this phone at /bend. Optional, if you also want each stage of recovery explained in plain words: JointClass, the class before and after surgery.